Tips on Creating a DIY ADA Stand

John N. · 05-06-2008, 01:50 AM

Please discuss and comment on Kristoffer Willerslev Jørgensen's Tips on Creating a DIY ADA Stand here.

-John N.

Roy Deki · 06-03-2008, 04:09 PM

Nice workmanship...Do you have any close up photos? Also I would like to know the material cost for this project.

Rastaman · 06-03-2008, 07:30 PM

Very neat job! I build mine on similar way (laminate-lined), but with less profesional tool - regarding to trimming the laminate with a router. Here is an alternative to do that with half-rounded rasp (for metal). It's going pretty fast, about 30 sec. per meter

You just have to grind only when going towards afore with rasp, to avoid laminate cracking. Picture will describe that better than me

Anti-Pjerrot · 06-04-2008, 03:47 AM

There are some more shots here

05-06-2008, 01:50 AM	#1 (permalink)
John N. Administrator Join Date: Oct 2007 Location: California Posts: 1,828	Tips on Creating a DIY ADA Stand Please discuss and comment on Kristoffer Willerslev Jørgensen's Tips on Creating a DIY ADA Stand here. -John N.

06-03-2008, 04:09 PM	#2 (permalink)
Roy Deki Honary Member Join Date: Feb 2008 Location: Chandler AZ Posts: 484	Nice workmanship...Do you have any close up photos? Also I would like to know the material cost for this project. __________________ http://i120.photobucket.com/albums/o...aapebanner.jpg www.aape.naturalaquariums.com

06-04-2008, 03:47 AM	#4 (permalink)
Anti-Pjerrot Moderator Join Date: Feb 2008 Location: Copenhagen, Denmark Posts: 753	There are some more shots here __________________ Scape it - Kristoffer

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY ADA 60 stand	Anti-Pjerrot	Equipment	39	10-09-2008 03:23 PM
Creating Waterfalls in Planted Aquariums	John N.	AquaScaping World Magazine Discussions	2	05-30-2008 07:24 PM
Creating Depth and Perspective in an Aquascape	John N.	AquaScaping World Magazine Discussions	1	05-07-2008 05:18 PM

06-03-2008, 07:30 PM	#3 (permalink)
Rastaman Junior Aquascaper Join Date: Feb 2008 Location: Croatia Posts: 36	Very neat job! I build mine on similar way (laminate-lined), but with less profesional tool - regarding to trimming the laminate with a router. Here is an alternative to do that with half-rounded rasp (for metal). It's going pretty fast, about 30 sec. per meter You just have to grind only when going towards afore with rasp, to avoid laminate cracking. Picture will describe that better than me