Quote:
Originally Posted by John N.
However, have you noticed any filter strain and wear? There's going to a lot of back pressure, and therefore will make your filter work harder to push the same volume out of the output.
-John N.
|
No I never noticed any problems. I would not think this would be a problem unless you get silly and cut the bar down to very few holes. To simulate the difference in flow minus two or three holes just reach in the tank and cover a few with your fingers and notice the increase in the flow. After you have and idea of how many to eliminate get out the trusty hacksaw.
If you think you have created to much restriction simply get a drill bit a little bigger than the original holes and drill them a little larger. In fact you can do this just to make your spraybar smaller without much increase in water flow.
Spraybars are cheap so in the past I bought a few to play around with flow in my tank.